OldTools Archive

Recent Bios FAQ

275151 Kirk Eppler 2022‑01‑25 Re: Brace question
Lower left in this image is a brace square tang to 3 jaw converter. Not
sure if someone makes a new one or not.

https://kirkhmb.smugmug.com/Woodworking/Woodworking-Tools/i-WnKPP5S/A

Some of the newer braces had jaws that would allow them to grip a round
shank with two jaws.  Forget which one now (Stanley 923 & 2101?), but it
was a patented feature.  Choking up on the bit May allow you to avoid the 3
flats, or the right jaws may ignore it.

The other pricey option might be here.

https://www.popularwoodworking.com/tools/hand-brace-adapter-for-woodowl-tri-cut-
bits/


Kirk in Half Moon Bay, CA

On Tue, Jan 25, 2022 at 9:29 AM Frank Filippone 
wrote:

> All of my braces are 2 jawed.  I recently purchased a set of auger bits
> that I wish to use ( Sears/Jennings 50-50) which have round shanks with  3
> flats in a 120 degree pattern.
>
> What do I need to find to make this combination work?
>
> --
>
> Frank Filippone
>
> BMWRed735i@G...
>
>
> 
>
>
> --
Sent from my iPad, apologies for the Auto Correct errors. Kirk

Recent Bios FAQ