thu, 03-apr-2008, 15:09

Chilling

chilling devil dog

I’m between jobs right now, so I took advantage of the vacation and spring weather to brew a batch of rye India pale ale, Devil Dog. It’s named after our dog Kiva and is a rich, copper colored beer with lots of alcohol and a nice balance between malt and hops. Three pounds of rye (to twelve pounds of pale malt and a pound and a half of crystal malts) adds a subtle hint of spicy earthiness. This is the third time I’ve brewed it, but I got an unexpectedly good yield, so it’ll be stronger than past incarnations.

My normal brewing efficiency has hovered around 70% for many years, but has been falling over the past five or six batches. I think this was partly due to some bad base malt, and partly due to a worn out mill. I got a new sack of Crisp Maris Otter, and replaced my old mill with a Monster 3-roller Mill. Initially, I was having trouble with whole grains getting stuck between the upper passive roller and the wooden base that supports the mill. When this happened, the mill would seize because the passive roller couldn’t spin. My solution was to cut a piece of sheet metal (a tin can, actually) to span the gap between the base and the passive roller, so that all the grains are fed directly between the two top rollers. So adjusted, the mill is fantastic. My last two batches have had yields of 79 and 81%, and I had no trouble sparging this recipe, even with three pounds of rye malt in the mash.

Kiva

kiva

The top photo shows my current chilling setup. I leave a 55-gallon barrel of water (the barrel up on the deck) out overnight to get cold, and pump this cold water through my plate chiller (on the steps) into a second barrel (the one on the ground). The beer drains by gravity through the other half of the chiller into the fermentation bucket. I monitor the temperature as the wort exits the chiller, and keep an eye on the temperature in the bucket with a digital meat thermometer. In my last batch I had trouble with the chiller cooling the boiling wort to much because the water was very close to freezing. But this time I figured out the correct combination of pump speed and output valve setting so I could adjust the temperature of the chilled wort without stalling the pump. Once the Creek thaws (it’s right behind the cabin), I’ll be able to use it for chilling instead of hauling my own chilling water.

Assuming the yeast is up to the task of this 1.086 gravity wort, I should be enjoying a pint of Devil Dog in six to eight weeks.

wed, 02-apr-2008, 08:39

Deuce with a bowl

deuce with a bowl

The weather is turning toward spring: there’s water on the Creek, the snow is melting away, and every day it seems like the days are noticeably longer. The sled dogs always go a bit crazy at this time of year because the dog yard is still covered with snow, but their racing season is over. This appears to have affected Deuce more than the other sled dogs. He’s always played with “his” food bowl in the dog yard, but in the last few days he’s started picking up the dog bowls in the house and carrying them around. The photo shows him pacing back and forth in front of the couch with one of the bowls. It’s very cute.

Hopefully once the snow melts and we can spread the wood chips around again, they’ll get into lazy summer mode and Deuce will relax.

tags: Deuce  dog mushing  spring 
sun, 30-mar-2008, 10:29

recharging glycol

recharging glycol

When we first moved into our new house I was pleased that the system for keeping the water and waste water lines running in winter was based on circulating warmed glycol, rather than electrical heat tape. Heat tape is known to fail without warning, and sometimes even shorts out and starts a fire.

Unfortunately, the setup is quite peculiar. We’ve got a small heating-oil-fired boiler (the white box on the left of the photo) that heats an internal five gallon water tank. A circulating pump from this tank runs into a plate heat exchanger with the hot water on one side and circulating glycol on the other. A second circulating pump circulates glycol out to the water tank, and back around to the discharge pipe running to the sewage treatment plant. With the boiler set around 165°F, the glycol stays between 80–100°F, depending on the temperature outside. The guy who built the place also ran lines to all the bedrooms and the living room so that hot water or glycol could be used to heat the house, rather than using the small, self-contained Monitor heater we’re using now.

There are a couple problems with this system. In order for the boiler to keep the glycol warm enough via the exchanger, the water temperature has to be quite a bit warmer than is usual for a domestic hot water supply. That’s dangerous for someone not familiar with how hot the water will be when it comes out of the tap, and it’s not all that efficient to keep the hot water at such a high temperature. It also seems like this high temperature is necessary to provide for enough hot water that a normal-length shower will stay warm throughout. And there’s no way the boiler would be up to the task of heating radiators throughout the house, in addition to what it’s doing now.

But the more immediate problem is that the glycol lines were accidentally cut and then improperly repaired before we moved in. We were told that the repair was successful, but when the temperature got cold this winter, glycol started leaking out of the repair. Since the glycol lines are plastic, there’s no way to fix the leak during winter. And even when the lines aren’t leaking at low temperatures, air is slowly drawn into the lines through the same faulty repair. After a couple months, the amount of air in the circulating lines is large enough that the lines become really noisy.

The way to get all the air out of the lines is to recharge the glycol, a procedure I performed for the third time this weekend. This involves connecting a transfer pump to the two sides of the circulating loop with a bucket of glycol in the middle. The procedure is to hook up the transfer pump, turn off the circulating pump, turn on the transfer pump, open the system and allow the transfer pump to circulate glycol for fifteen or twenty minutes until the air has been removed. Then close the return side of the glycol lines and allow a bit of pressure to develop before closing the supply side and turning off the transfer pump. Since the system doesn’t need any pressure at all to operate, the last step before turning on the circulating pump is to carefully open one side of the glycol system and allow most of the pressure in the system to force out the remaining glycol. It’s possible that leaving pressure in the lines might force a bit of glycol out of the leak, rather than allowing air into the system, but I’d rather recharge the lines every couple months than deal with a glycol spill.

This weekend is the Home Show, where a bunch of vendors get together in the Carlson Center and show off their products. I’m hoping we can get some suggestions and ideas from people about a better setup for the house. I have a feeling that a larger boiler, combined with a small hot water storage tank might be a better system. The boiler would be heating water or glycol for the outdoor lines, water for radiators in the house, as well as keeping the hot water storage tank warm for our hot water supply. The space we have available (in the photo) isn’t very large, so we may need to build a small bump out on the back of the house to accommodate the new equipment. Anyway, I’m hoping we can come up with something and maybe even get it installed this summer so we can go through next winter without worrying about what will happen when our small boiler fails (which it did at one point this winter).

sat, 29-mar-2008, 13:39

In Defense of Food

406 cubicle zero, akasofu building, 2002

You may have noticed that this blog (and the rest of my site) has moved to a commercial web hosting provider. After nine years and three months, I’m leaving my job at IARC for a new position at ABR, Inc. ABR is an environmental consulting firm that has been in business in Fairbanks for more than 30 years. They’ve got an excellent reputation in Fairbanks for being a great place to work, and they take their responsibilities toward their employees and the environment very seriously. The new job is much the same as my job at IARC: supporting scientists in their work, and trying to find ways to use technology to help them do their jobs more effectively.

It’s very exciting for me, but at the same time, leaving my office and my co-workers at IARC has been very difficult. After nine years of working with the same group of people, I’ve come to consider many of them my good friends and it is going to be a real struggle to walk out on April 1st. Add to that, this is the first professional job I’ve ever had. I’ve had a lot of jobs (graduate student, teaching assistant, warehouse worker, office director, short-order cook, etc.), but IARC is the place where I learned to be an IT professional, and it’s because of IARC that I was able to get the job at ABR.

Changes: Hard + Good.

tags: friends  IARC  job  moving  work 
thu, 13-mar-2008, 09:32

In Defense of Food

in defense of food. photo by cafemama

Another fantastic book from Michael Pollan. This one is a very quick consideration of what food has become in our society, how it has affected our health, and how we can escape the obvious perils that this diet has caused. The first section considers the rise of “nutritionism,” and if you read his article on the subject from The New York Times Magazine, much of this material will be familiar. The argument is that the discovery of macro- and micro-nutrients has allowed scientists, journalists, and industrial food producers to keep consumers focused on the nutrients in food rather than the food itself. This is important because as food producers began modifying food into food-like substances, they could use the science of nutrition to enrich their food-like substances with what scientists were telling the public they needed. So when you refine whole wheat grains into white flour, you eliminate most of the nutrients from the grains. No problem: just add those nutrients back in. Unfortunately, the evidence suggests that this doesn’t work. Food isn’t just a collection of nutrients, and a loaf of nutrition-enriched bread-like substance made from refined grains, chemical additives and preservatives won’t give you the same benefits of a real loaf of bread made from whole grains, yeast, salt and water.

The second section discusses the “Western Diet,” and how unhealthy it is. He defines the Western Diet as a diet with “lots of processed foods and meat, lots of added fat and sugar, lots of everything except fruits, vegetables, and whole grains” (page 89). As a result of this diet, fortified with all the nutrients and vitamins science tells us we need, two-thirds of Americans are overweight, one-quarter have metabolic syndrome, and the incidence of type 2 diabetes has been going up by 5 percent every year since 1990. The United States is now 45th in the world for life expectancy at birth. The interesting (and hopeful) thing is that the health consequences of this diet can be rapidly reversed by eating differently.

The last section of the book offers some advice on how to modify your own diet in the form of a series of rules. For example, one of the best rules is this one:

Avoid food products containing ingredients that are a) unfamiliar, b) unpronounceable, c) more than five in number, or that include d) high-fructose corn syrup.

This is a tough one to follow. Earlier in the week I went to the supermarket to get hamburger buns, and there were none on the shelf that would be allowed under this rule. All of them had high-fructose corn syrup in them. Short of making my own (which I may try tomorrow), I have no valid choices at the supermarket. All the hamburger buns available don’t really qualify as food.

All the rules are condensed down to one short statement that appears on the cover: “Eat food. Not too much. Mostly plants.” But despite the simplicity of that prescription, reading the book is well worth it. It’s a very quick read, and really brings the point home that we need to think more critically about what we’re eating in this country.

tags: book review  books  food 

Meta Photolog Archives